status

BigMike · July 05, 2011, 07:25:00 AM

First, consider these options...

Then take a look at how the 222D rally car's above the cab air intake. Pretty sweet!

BryanH · July 06, 2011, 08:25:53 AM

Hey did you guys (Mike, Bill?) pick up the plethora of MR2 parts from the side of my house yet? Got an email from my parents last week I think saying the stuff was still there. My internet connectivity is very limited for now so I can barely check in once a week. Don't call/text as my phone is still on AT&T and it costs a fortune. Best way to contact me for now is email (bryan64@gmail.com) but even that is sketchy for the moment. Trying to unlock my phone to use a UK sim card but it's not going well....

Anyway, gotta go, just wanted to check if you guys got the parts yet.

Sirdeuce · July 06, 2011, 07:05:53 PM

Sorry Bryan, not yet. Our schedules haven't been cooperating.

BigMike · July 07, 2011, 08:48:23 AM

Bill, I'm able to meet you out there either today after work, tomorrow after work, or sometime this weekend (I'll be in town).

Mike

Sirdeuce · July 07, 2011, 07:38:01 PM

I work 'til 2:30 Saturday if that works.

BigMike · July 08, 2011, 11:22:45 AM

Later Saturday afternoon is good for me as I have to head up to Oakhurst around 5-6pm and I can meet you out at Bryan's on my way outta town. Can you hang around in town until 4 or 5p?

Sirdeuce · July 08, 2011, 07:58:03 PM

text tomorrow

Sirdeuce · July 31, 2011, 09:49:44 PM

Accepting donations for supplies

We need piston rings and plywood. And so on.......

BigMike · August 04, 2011, 09:34:42 PM

I've got $20

Sirdeuce · August 05, 2011, 08:33:38 PM

I got $20 and a handful of change

Sirdeuce · August 06, 2011, 09:01:19 AM

I'll bring you my $20 and you can get the epoxy resin for the car. How's that sound?

BigMike · August 15, 2011, 11:54:54 PM

I've got $20, now where do I buy this sacred epoxy resin?

BigMike · August 17, 2011, 02:39:35 PM

How about this one Bill? Please give me the green light to buy this:

http://cgi.ebay.com/280255931847
EPOXY RESIN MARINE BOAT BUILDING HIGH IMPACT 32 OZ.KT

Sirdeuce · August 17, 2011, 08:42:04 PM

That'll work. Might need more later, but should go pretty far.

Sirdeuce · September 02, 2011, 08:40:05 AM

At long last! New modification! Cut the bottom rear sheetmetal. Now, to figure the way to install the corrugated plastic sheet. Hmmm, follow the contour of the suspension brackets? Just go flat across the bottom? There is still a lip about 1/2" wide around the cut out. Good place to install reinforcing for the covering.